microA1-C sil0680 no SLB found

[alexdran]

I have a problem with my uA1, everything was configured correctly with my SIL0680 and
1HD with OS4.1 Final (update1) + CDRom on on channel
and second HD with DVD Burner on second channel

after having replaced battery on the board I had to set again uBoot config,
but now there is no way I can boot again from SIL0680

I only succeed to boot from original IDE OS4.1 CD (update1 or Final)

I always get:
Bus 0 not available, Bus 1 not available
no SLB found in any of the designated boot sources

I have set:
sii0680ide_conf=1212
sii0680ide_xfer=GGGG

there were other commands to type,
what was the way to tell uBoot to scan SIL0680 devices instead of original IDEs ones ?


I have tried also from OS4.1 Final CDRom and uBoot prefs
setting as boot options
1. parallel sil CDRom
2. parallel sil HD
3. IDE Cdrom

with no chance

many thanks in advance for any help !!!!

[alexdran]

solved !!!
apparently problem was the cable, not fitted correctly in SIL card
now I succeed to boot!!!