Page 1 of 1
[SAM440ep-Flex] J17 port - SOLVED!!
Posted: Mon Sep 12, 2011 8:05 pm
by AmiSpaTra
I've installed a frontal hub (Digitus DA-70133-2 - VPR3.0). The manufacturer says what this support USB 1.1 and 2.0.
I've plugged into J19A connector and this works,
but with this new AmigaOS 4.1.3 release I've changed to J17 connector (port #5)... however now the hub don't work 8'^(.
I've plugged an USB key and the system don't recognize it (and all leds from the hub continues off). Hints?
Regards
Re: [SAM440ep-Flex] J17 port
Posted: Mon Sep 12, 2011 11:01 pm
by Spectre660
I observed the same thing with J17. I had disconnected my internal multicard reader a few weeks ago and tried to plug it in on Sunday but nothing worked with J17. The cable is not long enough to connect to J19A so I did not try that at the time. I am now also running Update 3 .
AmiSpaTra wrote:I've installed a frontal hub (Digitus DA-70133-2 - VPR3.0). The manufacturer says what this support USB 1.1 and 2.0.
I've plugged into J19A connector and this works,
but with this new AmigaOS 4.1.3 release I've changed to J17 connector (port #5)... however now the hub don't work 8'^(.
I've plugged an USB key and the system don't recognize it (and all leds from the hub continues off). Hints?
Regards
Re: [SAM440ep-Flex] J17 port
Posted: Tue Sep 13, 2011 4:54 am
by Spectre660
Still not working
Guess that we should read the Manual .
System:Documentation/usb/usb_ohci_readme
The OHCI driver supports following UBoot variables:
usb_enable_4x0 - if set to "on" or "1", the ohci interface
of the PPC 440ep or PPC 460ex cpus are activated.
Re: [SAM440ep-Flex] J17 port
Posted: Tue Sep 13, 2011 4:04 pm
by AmiSpaTra
You said...
Spectre660 wrote:Guess that we should read the Manual .
You are my hero. SOLVED
, thanks.