Page 1 of 1

microA1-C sil0680 no SLB found

Posted: Sat Feb 22, 2020 2:18 pm
by alexdran
I have a problem with my uA1, everything was configured correctly with my SIL0680 and
1HD with OS4.1 Final (update1) + CDRom on on channel
and second HD with DVD Burner on second channel

after having replaced battery on the board I had to set again uBoot config,
but now there is no way I can boot again from SIL0680

I only succeed to boot from original IDE OS4.1 CD (update1 or Final)

I always get:
Bus 0 not available, Bus 1 not available
no SLB found in any of the designated boot sources

I have set:
sii0680ide_conf=1212
sii0680ide_xfer=GGGG

there were other commands to type,
what was the way to tell uBoot to scan SIL0680 devices instead of original IDEs ones ?


I have tried also from OS4.1 Final CDRom and uBoot prefs
setting as boot options
1. parallel sil CDRom
2. parallel sil HD
3. IDE Cdrom

with no chance :x :x :x

many thanks in advance for any help !!!!

Re: microA1-C sil0680 no SLB found

Posted: Sat Feb 22, 2020 4:07 pm
by alexdran
solved !!!
apparently problem was the cable, not fitted correctly in SIL card
now I succeed to boot!!!