Three times booting my renovated SAM460ex the process has stopped with a Smart Data Filesystem Request.
Code: Select all
Data has a blockid error in block 13888. Expected was blockid 0x4F424A43, but the block says it is blockid 0x00000000."
The third time was a few minutes ago, when I had "cancelled" and finished booting and decided to run Directory Opus 5. That process was also interrupted by this same error message, but continued to a working DOpus5 screen when I cancelled.
I wonder about that "Data" first line. My disk (borrowed from my late X1000) has a partition named Data:. Could that perhaps be the reference? Any good way to find out for sure? I belatedly think the first step is to make sure I can open that partition OK, but having written this much, I'm going to go ahead and post before I take a chance on crashing the system.
OK, I opened Data: and looked at a few files and nothing bad happened. So what gives?