Hyperion Entertainment Message Boards

I swapped out my AmigaOne X1000 stock Radeon 6850 card with a Radeon 7850. However, when entering my new screenmode.prefs manually I entered 1920x1200, when I should have entered 1920 x 1080. My Dell 24" monitor cannot display 1920 x 1200 and as a result cannot display anything but an error message ...

OK, been a long time since I addressed this issue, but happily the problem was solved.

My X has a good Radeon card in it (6870) but apparently there have been a lot of fan issues with it, and a dying fan motor appearded to be my issue.

I started timing the display screen blankings. They went like ...

Update. I have the Radeon 6870 card, with two DVI connectors. I attached an identical Dell 24" monitor on second port with brand new cable. After 3-4 minutes both went out. I was running AmigaAMP at the time for "activity". I opened case, unscrewed card and resat it, though it appeared to be in fine ...

Even with screenblanker disabled it still goes into Power Save mode in about 2 minutes. I got another monitor of the exact same model and will swap 'em tomorrow to see if the problem is monitor or X1000 sourced. More then

Thanks for replying Andy. It may indeed have something to do with Screen Blanker prefs. First to be accurate, the monitor actually is a Dell 2313H, and the message is "Power Save Mode". This occurs during activity.

I check my prefs and Screen Blanker was set to 600. I thought it might be smart to ...

Recently I took my X1000 to high school (where I am a technology teacher-ah, the irony!) and displayed the X at "Technology Night", where it was a big hit.

However after coming home a new problem has surfaced that never existed before I transported it back and forth...the X1000 boots fine and ...

I am 100% sure this is my fault.

I successfully installed and booted FE. But it seemed slower because I set my partitions to 4096 block size. So I reinstalled and somehow blew up my boot partition (CFE?). I should mention that FE installs correctly on my system partition, with no error messages in ...

Thanks very much guys. I attempted to copy my Update 5 recovery disk to DH0: and while that worked, I experienced some OS issues (inability to clean up window by name etc) so I bit the bullet and followed Dan's suggestion on formatting and doing a clean install.

I formatted DH0: reinstalled Update ...

thanks, here are some better details of the issue.

I was attempting to edit AmiDock. After my last install of Jack the docks had two version of Jack and I wished to remove the old one. Every time I would right click to edit the dock the guru med. would appear. I'm on update 6 btw and AmiUpdate ...

Looks like I have lost the file or deleted it for my X1000. I was attempting to fix an AmiDock issue where I could not longer edit the dock and self-caused further issues. Could someone please post the standard X1000 DEVS: Mountlist file please in text?