Hyperion Entertainment Message Boards

I have a multiboot setup using os3.9/4.0/4.1fe and don't using any scripts. I just use the early startup menu and the bootdevice kickstart module.

3.9 will always be the default booting partition so you will need to set the bootpriority of the 3.9 partition higher than the 4.1 partition as when ...

Yes, I do have OS4.1FE running on my 1200. To beable to install the OS you will need to connect your harddrive to your primary master and your CD/DVD drive to your primary slave as the secondary connector will not work while installing the OS. Then you can use the boot floppy and the CD should be ...

I have the MK2 and you need to use the 68k drivers from Elbox to get it to recognise devices under OS4.

On an unfixed board the USB ports can not detect usb devices being inserted and removed. It should be able to detect usb devices from boot up or you might have better luck using a powered usb hub.

An updated version of Partition Wizard is in A-eon's Enhancer Software Pack.

Partition Wizard doesn't work at all with 4.1FE. If you have an older version of a 4.1 CD you might be able to use that instead to fix it as that is the only thing which support FFS2.

I use a

1GB MICRON MT36LSDF12872G-133C1 PC133R PC133 CL3 ECC SDRAM SERVER MEMORY

http://www.ebay.co.uk/itm/171620450837

which I luckily picked up on ebay cheap and it runs very stable for me but somebody else who has tried the same memory had problems with it but it might of not of been the ...

If you would like to test your memory you could try

http://os4depot.net/index.php?function=showfile&file=utility/hardware/memtester.lzx

and it is best to only use only one memory module as using two can cause memory corruption unless you are really lucky to find two modules which will work ...

My setup:

AmigaOne XE 800mhz G4
1GB Ram
Radeon 9250 AGP card
Soundblaster Live
SII0680 IDE card
RTL8139 Network card

I had no problems at all setting up 4.1 FE on my system on a clean hard drive with a SWAP partition on my hard drive but if I use the SWAP partition for example copying more the 1GB ...

Partition Wizard doesn't work properly at all on FE it did work under 4.1 update 6. I have tested it on both my XE and classic machines and it doesn't find partitions at all.