Hyperion Entertainment Message Boards

Hi all

Just installed 4.1FE this evening, but I'm stuck in 1024x768 instead of 1920x1080.

Prefs/Screenmode reports that I am using a mode called "Board0" where in 4.1.6 it said (I think) "RadeonHD".

The monitors tab shows the 6570 card. There is an entry in Devs:Monitors for the 6570 too but it says "Could not create graphics board context for 'Radeon HD 6570" when double-clicked.

How can I get the RadeonHD into Prefs/Screenmode/Available Modes?

Thanks

Jason

Have you updated the RadeonHD driver? Don't forget FE uses a restricted driver just for the install.
I also noticed the change to Board1 and Board0 for my RadeonHD and Radeon9250 cards.

Thanks for your input, ddni! It made me check that I'd installed it, which I knew defintely had from the Amistore, but I checked anyway. However, I read in the 1.2 readme that it was an *update*, which made me think that I needed to install the 1.0 driver as a baseline.

I'm not sure if that's the case, but it now works fine - so the resolution was to install 1.0 then 1.2 on the top of it. I wonder if a simple re-install of 1.2 would have fixed it too, but now that it's working I'm going to stop fiddling with it

Glad you got it sorted.
Do you still see the gfx card as board0 or do you see the card name?

ddni wrote:Glad you got it sorted.
Do you still see the gfx card as board0 or do you see the card name?

I still see it as "Board 0"

Cheers

Jason