Hyperion Entertainment Message Boards

Downloading to install and report shortly.

Usually my X5000 boots on HDMI and them moves to the Firepro under DVi. Under kernel 4.21 it boots to my Radeon SI card with no output from the Firepro at all.

Wiill update in a few minutes.

ace

Christian
From 4.20 final

allan@Amigaone:~$ dmesg | grep -i drm
[ 0.914842] [drm] radeon kernel modesetting enabled.
[ 0.915126] [drm] initializing kernel modesetting (VERDE 0x1002:0x683F 0x1682:0x7251 0x00).
[ 1.236049] [drm] Detected VRAM RAM=1024M, BAR=256M
[ 1.236054] [drm] RAM width 128bits DDR
[ 1.236201] [drm] radeon: 1024M of VRAM memory ready
[ 1.236208] [drm] radeon: 2048M of GTT memory ready.
[ 1.236226] [drm] Loading verde Microcode
[ 1.236277] [drm] Internal thermal controller with fan control
[ 1.247194] [drm] radeon: dpm initialized
[ 1.248166] [drm] Found VCE firmware/feedback version 50.0.1 / 17!
[ 1.248185] [drm] GART: num cpu pages 524288, num gpu pages 524288
[ 1.252189] [drm] PCIE gen 2 link speeds already enabled
[ 1.295645] [drm] PCIE GART of 2048M enabled (table at 0x00000000001D6000).
[ 1.318246] [drm] Supports vblank timestamp caching Rev 2 (21.10.2013).
[ 1.318252] [drm] Driver supports precise vblank timestamp query.
[ 1.318361] [drm] radeon: irq initialized.
[ 1.793122] [drm] ring test on 0 succeeded in 1 usecs
[ 1.793134] [drm] ring test on 1 succeeded in 1 usecs
[ 1.793143] [drm] ring test on 2 succeeded in 1 usecs
[ 1.793163] [drm] ring test on 3 succeeded in 10 usecs
[ 1.793174] [drm] ring test on 4 succeeded in 4 usecs
[ 1.963632] [drm] ring test on 5 succeeded in 2 usecs
[ 1.963643] [drm] UVD initialized successfully.
[ 2.069590] [drm] ring test on 6 succeeded in 22 usecs
[ 2.069608] [drm] ring test on 7 succeeded in 4 usecs
[ 2.069614] [drm] VCE initialized successfully.
[ 2.069828] [drm] ib test on ring 0 succeeded in 0 usecs
[ 2.069880] [drm] ib test on ring 1 succeeded in 0 usecs
[ 2.069928] [drm] ib test on ring 2 succeeded in 0 usecs
[ 2.069978] [drm] ib test on ring 3 succeeded in 0 usecs
[ 2.070025] [drm] ib test on ring 4 succeeded in 0 usecs
[ 2.721426] [drm] ib test on ring 5 succeeded
[ 3.225424] [drm] ib test on ring 6 succeeded
[ 3.729424] [drm] ib test on ring 7 succeeded
[ 3.730074] [drm] Radeon Display Connectors
[ 3.730081] [drm] Connector 0:
[ 3.730086] [drm] DP-1
[ 3.730090] [drm] HPD4
[ 3.730096] [drm] DDC: 0x6540 0x6540 0x6544 0x6544 0x6548 0x6548 0x654c 0x654c
[ 3.730102] [drm] Encoders:
[ 3.730108] [drm] DFP1: INTERNAL_UNIPHY2
[ 3.730113] [drm] Connector 1:
[ 3.730117] [drm] HDMI-A-1
[ 3.730121] [drm] HPD1
[ 3.730127] [drm] DDC: 0x6570 0x6570 0x6574 0x6574 0x6578 0x6578 0x657c 0x657c
[ 3.730133] [drm] Encoders:
[ 3.730138] [drm] DFP2: INTERNAL_UNIPHY2
[ 3.730142] [drm] Connector 2:
[ 3.730147] [drm] DVI-I-1
[ 3.730151] [drm] HPD2
[ 3.730156] [drm] DDC: 0x6560 0x6560 0x6564 0x6564 0x6568 0x6568 0x656c 0x656c
[ 3.730163] [drm] Encoders:
[ 3.730167] [drm] DFP3: INTERNAL_UNIPHY
[ 3.730172] [drm] CRT1: INTERNAL_KLDSCP_DAC1
[ 3.857467] [drm] fb mappable at 0xC005D9000
[ 3.857475] [drm] vram apper at 0xC00000000
[ 3.857480] [drm] size 11059200
[ 3.857484] [drm] fb depth is 24
[ 3.857489] [drm] pitch is 10240
[ 3.935333] radeon 0000:01:00.0: fb0: radeondrmfb frame buffer device
[ 3.935525] [drm] Initialized radeon 2.50.0 20080528 for 0000:01:00.0 on minor 0
[ 3.935972] [drm] initializing kernel modesetting (RV620 0x1002:0x95CF 0x1002:0x2143 0x00).
[ 4.066547] [drm] GPU not posted. posting now...
[ 4.069602] [drm] Detected VRAM RAM=256M, BAR=256M
[ 4.069696] [drm] RAM width 64bits DDR
[ 4.069783] [drm] radeon: 256M of VRAM memory ready
[ 4.069880] [drm] radeon: 2048M of GTT memory ready.
[ 4.069994] [drm] Loading RV620 Microcode
[ 4.070096] [drm] Internal thermal controller with fan control
[ 4.070253] [drm] radeon: power management initialized
[ 4.070400] [drm] GART: num cpu pages 524288, num gpu pages 524288
[ 4.074467] [drm] enabling PCIE gen 2 link speeds, disable with radeon.pcie_gen2=0
[ 4.117322] [drm] PCIE GART of 2048M enabled (table at 0x0000000000142000).
[ 4.125514] [drm] Supports vblank timestamp caching Rev 2 (21.10.2013).
[ 4.125644] [drm] Driver supports precise vblank timestamp query.
[ 4.126071] [drm] radeon: irq initialized.
[ 4.156753] [drm] ring test on 0 succeeded in 1 usecs
[ 4.326293] [drm] ring test on 5 succeeded in 1 usecs
[ 4.326407] [drm] UVD initialized successfully.
[ 4.326689] [drm] ib test on ring 0 succeeded in 0 usecs
[ 4.977487] [drm] ib test on ring 5 succeeded
[ 4.978061] [drm] Radeon Display Connectors
[ 4.978146] [drm] Connector 0:
[ 4.978208] [drm] DP-2
[ 4.978259] [drm] HPD2
[ 4.978313] [drm] DDC: 0x7e60 0x7e60 0x7e64 0x7e64 0x7e68 0x7e68 0x7e6c 0x7e6c
[ 4.978465] [drm] Encoders:
[ 4.978527] [drm] DFP1: INTERNAL_UNIPHY
[ 4.982995] [drm] Connector 1:
[ 4.987305] [drm] DP-3
[ 4.991585] [drm] HPD4
[ 4.995838] [drm] DDC: 0x7e20 0x7e20 0x7e24 0x7e24 0x7e28 0x7e28 0x7e2c 0x7e2c
[ 5.000225] [drm] Encoders:
[ 5.004605] [drm] DFP2: INTERNAL_UNIPHY
[ 5.204247] [drm] fb mappable at 0xC20543000
[ 5.208705] [drm] vram apper at 0xC20000000
[ 5.213037] [drm] size 8294400
[ 5.217350] [drm] fb depth is 24
[ 5.221654] [drm] pitch is 7680
[ 5.226036] radeon 1000:05:00.0: fb1: radeondrmfb frame buffer device
[ 5.230478] [drm] Initialized radeon 2.50.0 20080528 for 1000:05:00.0 on minor 1
[ 8.510093] drmem: No dynamic reconfiguration memory found
[ 41.812184] [drm:.radeon_dvi_detect] *ERROR* HDMI-A-1: probed a monitor but no|invalid EDID
allan@Amigaone:~$

Hi Ace,

I don't see any differences except [ 41.812184] [drm:.radeon_dvi_detect] *ERROR* HDMI-A-1: probed a monitor but no|invalid EDID but the kernel 4.20 works for you without any problems. Could you please remove the 7750 and test the alpha1 again?

Thanks,
Christian

Christian
I triedd removing the SI card but I do not get any output at all from the Firepro. Reverted back to 4.20 and all is well again. Sorry.

ace

acefnq wrote:Christian
I triedd removing the SI card but I do not get any output at all from the Firepro. Reverted back to 4.20 and all is well again. Sorry.

ace

Hi Ace,

Sorry because of this issue. I will compile a test kernel without the latest DRM updates for testing. I need error messages or something like that for reporting this issue to the kernel developers.

Cheers,
Christian

Hi All,

I released the alpha2 and the alpha3 of kernel 4.21 for testing today.

New (alpha2):

• X5000: Additional uImage without DRM updates 'drm-next-2018-12-14' for Ace

New (alpha3):

• X1000: The kernel developers integrated Darren's Nemo patches to the official kernel source code so we don't need the Nemo patch anymore.
• X5000: New Cyrus patch 4.21-1
• PowerPC updates 4.21-1

New (alpha2+3):

• Linux Git log
• Phoronix articles, reviews and news stories covering Linux 4.21

Downloads:

• vmlinux-4.21-alpha2-AmigaOne_X1000_X5000.tar.gz
• vmlinux-4.21-alpha3-AmigaOne_X1000_X5000.tar.gz

Please test them.

Thanks,
Christian

Alpha3 up and running. Would be great if we somehow could find a way to get the onboard DPAA ethernet working. (As the Terminal screenshot shows,...it does get probed as ETH0 and ETH1 but still not usable )



Big picture. http://www.skateman.nl/wp-content/uploa ... 205143.png

Christian
Thanks for taking the effort to recompile a version without DRM. Good news, it boots to my Firepro and Compiz works. So indeed it seems the new DRM changes are the source of the issue. It appears there are some significant changes for Southern Island cards included in 4.21 but Mesa 19 is required. However, it doesn't appear that the changes include 3d as yet.

Thanks again.

ace

Hi Skateman,
Hi Ace,

Thanks a lot for testing the alphas!

@Ace
The problem is, that we don’t have any error messages or something like that for reporting this issue to the kernel developers. Could you please look in the Xorg log files?

If a problem occurs, view the log stored in either /var/log/ or, for the rootless X default since v1.16, in ~/.local/share/xorg/. GDM users should check the systemd journal. [4]

The logfiles are of the form Xorg.n.log with n being the display number. For a single user machine with default configuration the applicable log is frequently Xorg.0.log, but otherwise it may vary. To make sure to pick the right file it may help to look at the timestamp of the X server session start and from which console it was started.

Thanks,
Christian

Christian
Attached are the logs from xorg. Log 1 is the second alpha without DRM, Log 0 is for Alpha 3 (noting I didn't load kernel modules). Sorry can't figure how to attach separately as files as whatever extension I use is rejected and they are too large to copy and paste.



Ace