Fienix - New PowerPC Distro

[xeno74]

The VLC solution is on the way to the official kernel source code:

On 8. Apr 2019, at 15:03, Michael Ellerman <patch-notifications@ellerman.id.au> wrote:

On Thu, 2019-04-04 at 12:20:05 UTC, Christophe Leroy wrote:
Commit b5b4453e7912 ("powerpc/vdso64: Fix CLOCK_MONOTONIC
inconsistencies across Y2038") changed the type of wtom_clock_sec
to s64 on PPC64. Therefore, VDSO32 needs to read it with a 4 bytes
shift in order to retrieve the lower part of it.

Fixes: b5b4453e7912 ("powerpc/vdso64: Fix CLOCK_MONOTONIC inconsistencies across Y2038")
Reported-by: Christian Zigotzky <chzigotzky@xenosoft.de>
Signed-off-by: Christophe Leroy <christophe.leroy@c-s.fr>

Applied to powerpc fixes, thanks.

https://git.kernel.org/powerpc/c/dd9a99 ... 747e3366c5

cheers

[Tijatjj]

Hi ok so everything on usb was sda1/2 respectively.but tells me reading file then not found.designation was from the Linux prep .This is for the Fienix usb install.ok so it is just #7 on that device tree.stil can’t gett it to boot up says file not found ,using the uboot instructions from the Fienix download site any ideas. Using 0:1 says unable to read file uimage-4.18**.trying usb 0:2 says unrecognized file system type.

[caseycullen]

What are the commands you are entering?

Hi ok so everything on usb was sda1/2 respectively.but tells me reading file then not found.designation was from the Linux prep .This is for the Fienix usb install.ok so it is just #7 on that device tree.stil can’t gett it to boot up says file not found ,using the uboot instructions from the Fienix download site any ideas. Using 0:1 says unable to read file uimage-4.18**.trying usb 0:2 says unrecognized file system type.

[Tijatjj]

Hi thanks, the commands are the ones from the Fienix website but I just looked at the. Partition of the usb and it’s sdb1 and sdb2 so made mistake right there.als addedto cyrus boot the4.19 file from pictures

[Tijatjj]

Ok so here is what’s tried ,did try w/ correctly spelling pic and here’s pic of 64 gig usb drive.stiil not working to install on usb also have hd open to place it into.

[xeno74]

Please rename uImage-4.19 to uImage and try it again.

— Christian

[Tijatjj]

Thank you will try

[Tijatjj]

Ok that partly works but it says reading Cyrus file then unable to read file. Pics of the Cyrus partition boot files in there folders I redid it with correct spelling same thing

[Tijatjj]

Sub folders

[xeno74]

Hi Tijatjj,

You tried to boot a folder. This doesn’t work. Please copy only the uImage-4.19 and the cyrus_p5020_eth_poweroff.dtb to the FAT32 partition and delete the folders.

Thanks,
Christian