USB 3.x controller cards

[xeno74]

Are there any parameters which could be given to USB controllers/drivers, to adjust how they sync with the system...?

Sorry, I don’t know. What about the following error message?

Code: Select all

failed to load firmware renesas_usb_fw.mem

[Roland]

Sorry, I don’t know. What about the following error message?

Code: Select all

failed to load firmware renesas_usb_fw.mem

Yes, I noticed that, too... But shouldn't it be included with the kernel? On the manufacturer's site I did not see any LInux software, and none of the distros I have currently installed did have anything like that in /libs/firmware. Maybe there is no PPC version of it?

I tested again the Delock controller (ASM chipset) with the final version of 5.19. No change there, it still needs the 'mem=3500M' parameter in order to work. I did report this issue to the delveloper list you adviced earlier but there was not any reaction to my report.

[xeno74]

I did report this issue to the delveloper list you adviced earlier but there was not any reaction to my report.

Please ask again. Maybe they have forgotten to answer.

— Christian

[Roland]

Please ask again. Maybe they have forgotten to answer.

I doubt that... I already unsubcribed the list as it just fills my mailbox with messages from which I do not understand anything. It is clearly only for programmers, not for end users! But if you like, please feel free to 'bump' my report by your own comment. Maybe there will be more attention if a well-known developer is involved...

[xeno74]

Maybe there will be more attention if a well-known developer is involved...

Unfortunately, I am also not a developer. I am a Linux systemadministrator. I am fighting also with the developers. If I don’t use the problematic hardware then I have not really a chance to win the fight.