New X5000 build, USB won't start up

AmigaOne X5000 platform specific issues.
Post Reply
User avatar
Paul Zager
Posts: 14
Joined: Wed Jul 06, 2011 3:58 pm

New X5000 build, USB won't start up

Post by Paul Zager »

I got my new motherboard, Enhancer, and USB startup stick from Amiga kit, and assembled it all today. The USB boot stick from Amigakit is found OK. "Loading finished ######################### 100%" message comes up after a short time. Next Line reads: "About to call loader entry at 0x7BD02020" at which point it just hangs there. Also, at power on, sometimes the boing ball starts spinning and "shoots", other times the graphic just sits there. I choose to boot from Mass storage when I do get the menu. I burned a boot ISO from my Windoze computer , but when I try to boot from optical, it says no valid boot source was found. I have the SSD HD plugged into SATA 0, and the DVD/CD in SATA 1.

The graphics card is an RX550.

Any ideas what I should do?

Paul
A1-XE G4, 2GB, 9250, 4.1.4

Spectre660
Posts: 1493
Joined: Sat Jun 18, 2011 2:16 pm
Location: Montserrat

Re: New X5000 build, USB won't start up

Post by Spectre660 »

@Paul

It is possible that you don't actually have the driver for the Polaris card installed on the USB startup drive . It is currently sold as an extra pre release item of the the Enhancer 2.0 as Enhancer 2.0 has not been released yet. Solution is to try booting from a supported older model video card .

Post Reply