Hyperion Entertainment Message Boards

Here are the version numbers of P96LoadDefaultMonitor in update 4 and 5 (taken from information window):

Update 4: 1.1 (7.1.11) 68 356 bytes
Update 5: 53.1 (8.6.12) 7 756 bytes

Unbelievable, I must say...

So, you are right, this command might cause the problem...

acmn wrote:Here are the version numbers of P96LoadDefaultMonitor in update 4 and 5 (taken from information window):

Update 4: 1.1 (7.1.11) 68 356 bytes
Update 5: 53.1 (8.6.12) 7 756 bytes

Unbelievable, I must say...

My SAM440 Flex had "LoadMonDrvs" in the update4 startup-sequence which was replaced with "P96LoadDefaultMonitor" in update5. I guess I can delete "LoadMonDrvs" from C: now?

Both commands are in update 5 Startup-sequence,So dont.

xenic wrote:

acmn wrote:Here are the version numbers of P96LoadDefaultMonitor in update 4 and 5 (taken from information window):

Update 4: 1.1 (7.1.11) 68 356 bytes
Update 5: 53.1 (8.6.12) 7 756 bytes

Unbelievable, I must say...

My SAM440 Flex had "LoadMonDrvs" in the update4 startup-sequence which was replaced with "P96LoadDefaultMonitor" in update5. I guess I can delete "LoadMonDrvs" from C: now?

This I found out. The startup-sequence in update 5 is same for all platforms...interesting...

You could try Emailing Max at Acube as he may not have seen this thread .

acmn wrote:This I found out. The startup-sequence in update 5 is same for all platforms...interesting...

acmn wrote:This I found out. The startup-sequence in update 5 is same for all platforms...interesting...

Correct and intentional.

Well, except for the Classic platform which still has its own Startup-Sequence (since it has to start with the Bootloader command, for one thing).

Best regards,

Niels

Niels.

So, it seems that I can not use new PCIGraphics.card file in my AO500 which
has onboard graphics. Can you comment on that...

acmn wrote:Niels.

So, it seems that I can not use new PCIGraphics.card file in my AO500 which
has onboard graphics. Can you comment on that...

Not really, no. I don't have any problems like that, but I have a Radeon HD 4650 in my Sam460ex and don't use the onboard graphics.

Best regards,

Niels

It has been confirmed to me by Acube that this is the situation at the moment. You have to use the PCIGraphics.card file from Update 4.

acmn wrote:Niels.

So, it seems that I can not use new PCIGraphics.card file in my AO500 which
has onboard graphics. Can you comment on that...