Hyperion Entertainment Message Boards

I do not have a Sam (an X1000), but I too would like to know if this ESI Juli@ XTe (PCIe version) works properly. It seems like a recently released card, perhaps available from July this year. A few users including myself have the PCI version which works fine (just used the sound output myself). As ...

@ musa I think you need to have a printer with either: - a driver (or compatible) specifically supported - one that supports PostScript - one that supports certain versions of PCL Someone please correct me if I am wrong here as I have not used modern printers with my Amigas. If I were looking for a ...

I cut the gameport/parallel board like danbeaver did and have an internal-external scsi-68 adapter go through the now accessible hole (very very tight fit), and that connector terminated by an external scsi-68 terminator. You do have to be very careful to cut a straight line in that narrow 1-2mm gap...

danbeaver, please do tell about using the rtl8139 in a classic... was not aware it could be done. Then one could use RTL8139 in both os3.9 and 4.1 - not that I think it will offer much more speed (if any) than the rtl8029.

So the cable mystery is solved! There however is no custom Dual Link DVI-I cable for the CS1784A... so would have to additionally purchase the same Single Link DVI-I you specified if I was to get the CS1784A (after checking with Aten support). Too expensive for me at the moment. Back to the original...

Thanks for the clarifications regarding the Aten KVMs. It was not clear to me from the documentation, mainly because the higher model CS1784 says you need a custom DVI-I cable to be able to use analog output, whereas your model's manual is silent on how to hook it up. Bit silly if their custom dual ...

Ah, the Aten CS1764A (4 port version of yours) is the DVI-I version of mine (except it misses the OSD and mouse port switching). You have a good KVM there and I should expect behaviour should correlate with mine. I would consider the Dual Link DVI version of an Aten 4 port KVM, the CS1784A, in futur...

Yes, it could be the reason it works after you have plugged it in (i.e. USB1.x instead of USB2 ehci). I did not notice anyone having such an issue with USB 1.x KVMs/hubs. Are you able to capture the debug output from CFE and see if you get the ""ehci: aynch list not enabled" message w...

I have an Aten KVM switch that I have to connect via a USB 1.1 hub for it to work in the USB slot one would usually plug in the keyboard as you have described. Can you try to boot to the CFE command prompt without the Aten KVM connected, and then connect it to the above mentioned "keyboard"...

The ZorRAM will be automatically detected and used as swap. Please read the Classic FAQ questions 7.x and 8.x which contains a lot of information: http://forum.hyperion-entertainment.biz/viewtopic.php?f=15&t=92 You can even use both ZorRAM and hard disk swap if you like (with ZorRAM being used f...