Yes, thank you for your help.
May I should consider buying a new HD, as it's just a 120GB drive, split into system and data partition.
AmiUpdate is working well -just 4 updates are not applicable -but this is just fine tuning. :) And needed not so much time for the full setup. Just a little over ...
Search found 4 matches
- Tue Nov 11, 2014 9:23 am
- Forum: Platform: AmigaOne XE and MicroA1-C
- Topic: Update 4 fails
- Replies: 6
- Views: 18831
- Mon Nov 10, 2014 7:24 pm
- Forum: Platform: AmigaOne XE and MicroA1-C
- Topic: Update 4 fails
- Replies: 6
- Views: 18831
Re: Update 4 fails
Ah, it was an error in the downloaded update 3 -I've reloaded again, installed new from 4.1.1 and now it works! :)
But how can I use AmiUpdate for the latest Updates? Can't find it in the folders -as described it should be installed with update 6...
...found it -just rightclick in the WB.... :oops:
But how can I use AmiUpdate for the latest Updates? Can't find it in the folders -as described it should be installed with update 6...
...found it -just rightclick in the WB.... :oops:
- Mon Nov 10, 2014 10:12 am
- Forum: Platform: AmigaOne XE and MicroA1-C
- Topic: Update 4 fails
- Replies: 6
- Views: 18831
Re: Update 4 fails
Hmmm, OK.
It shouldn't take so much time until release date. And the pronounced price is really payable with 29.95€. I will buy final version, and may a second one -may I need it in a short time for another hardware.
Best regards
It shouldn't take so much time until release date. And the pronounced price is really payable with 29.95€. I will buy final version, and may a second one -may I need it in a short time for another hardware.
Best regards
- Sun Nov 09, 2014 5:49 pm
- Forum: Platform: AmigaOne XE and MicroA1-C
- Topic: Update 4 fails
- Replies: 6
- Views: 18831
Update 4 fails
Hi,
I've just updated from update from 2 to 3, and it's displayed in the workbench. But if I try to update to 4 it just starts, and after confirming and click "next" the window just disappears and nothing happens then. After restart 4.1 update 3 is displayed. I've tried to re-install 3 but then it ...
I've just updated from update from 2 to 3, and it's displayed in the workbench. But if I try to update to 4 it just starts, and after confirming and click "next" the window just disappears and nothing happens then. After restart 4.1 update 3 is displayed. I've tried to re-install 3 but then it ...