It would be nice if a "switch off" command could be added to the OS.
This is something that should be handled by the os in a consistent way. Currently there a different programms on os4depot.
I know it's not possible to support this for all OS4 machines, but it is possible for the sam440ep, sam440flex, sam460ex, peg2, x1000.
On not supported machines (CyberstormPPC, BlizzardPPC, and the old A1s) the command could simply fail and print a short message.
adding a "switch off" command
Re: adding a "switch off" command
Yes, this has already been addressed, and is currently being tested.
Simon
Simon
Re: adding a "switch off" command
NiceRigo wrote:Yes, this has already been addressed, and is currently being tested.
AmigaOS 4.1 FE on Sam440ep-flex @ 800MHz, 1GB RAM, Radeon 9250
Still waiting (or dreaming) for The Amiga revolution...
m4rko.com/AMIGA
Still waiting (or dreaming) for The Amiga revolution...
m4rko.com/AMIGA
- javierdlr
- Beta Tester
- Posts: 389
- Joined: Sun Jun 19, 2011 10:13 pm
- Location: Donostia (GUIPUZCOA) - Spain
- Contact:
Re: adding a "switch off" command
Did you try Poff from os4depot? Only sam460 and X1000 supported in current version.