To bad,.. even more issues with the DPAA Ethernet part.
(Click
http://www.skateman.nl/wp-content/uploa ... 202817.jpg for a bigger screenshot)
In the past the MII-tool did respond but now the outcome is:
SIOCGMIIPHY on 'eth0' failed: Invalid argument
SIOCGMIIPHY on 'eth1' failed: Invalid argument
no MII interfaces found
The DPAA Ethernet adapter does get probed.
[ 5.878766] fsl_dpaa_mac ffe4e6000.ethernet eth0: Probed interface eth0
[ 5.885851] fsl_dpaa_mac ffe4e8000.ethernet eth1: Probed interface eth1
Ethtool does give some info..
skateman@X5000LNX:~$ ethtool eth0
Settings for eth0:
Supported ports: [ MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Supported pause frame use: Symmetric Receive-only
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Advertised pause frame use: Symmetric Receive-only
Advertised auto-negotiation: Yes
Speed: 10Mb/s
Duplex: Half
Port: MII
PHYAD: 3
Transceiver: external
Auto-negotiation: on
Cannot get wake-on-lan settings: Operation not permitted
Current message level: 0x00000037 (55)
drv probe link ifdown ifup
Link detected: no
The DPAA Eth0 is connected to a Gigabit Switch but no activity or link led.
Will try to do some more testing..
AmigaOne X5000 -> 2GHz / 16GB RAM / Radeon RX 570 / Radeon X1950 / M-Audio 5.1 -> AmigaOS / Linux
Amiga 1200 -> Recapped / 68ec020 ACA 1221ec / CF HDD / RetroNET connected to the world
Vampire 4SA - RPi4 Running AmiKitXE Full