I had to take photos, but I'll just copy here:nbache wrote:What exactly happens when you start the machine with the CD in the drive?kilaueabart wrote:My SAM460ex boot disk came today. Putting it in the CD tray has so far changed nothing.
Code: Select all
[some kinda picture]Sam460ex
power for free minds
Config: PCIe 4x + PCIe 1x
USB: scanning bus for devices... 7 USB Device(s) found
scanning bus for storage devices... 3 Storage Device(e)s found
SATA Device 0: not available
Press SPACE for prefs, ENTER for boot select, ESC for prompt
Booting... 4
Screen changes.
Code: Select all
AOS4 FLB
FLB: no SLB found in any of the designated boot sources: return[photo cut off here. I'm not 100% sure of the "return"; I take fuzzy photos.]
Press any key to continue
I did reset mine to 1, and I'm sure I saveenv'ed. I'll recheck that the next time I reconnect all the cords to the SAM, but apparently it had no effect....
If you look at the screen at the very start of booting, it first says it is scanning for USB devices. Then, on mine, it says it is scanning for USB storage devices. I have scan_usb_storage set to 1. I bet if you were to set yours to 1 as well, it would do that scan also.
Mine now match, except for the IP address things, and I haven't bothered putting boot2 and boot3 in. Oh, and I haven't redone os4_commandline.Here are my UBoot variables for comparison.
...
I hope you, or someone, will find a clue in this data. I haven't heard anything from AmigaKit about fixing my X1000.