Niolator wrote:But how can I read the data on SFS partitions then? I just installed AmigaOS 4.1 FE on my X5000. I used my old hard drive from my SAM 460 as I have a lots of data on two SFS-partitions that I want to use on my X5000. The problem is that I can't see my old SFS-partitions in other places than the media toolbox. They show as SFS/00. That is SFS0, right? I thought it was just SFS2 that was no longer supported in AmigaOS 4.1.
If I can't get them to show in Workbench there has got to be a way to access them so I can move the data to a partition with a supported type of filesystem.
kas1e wrote:@Niolator
Don't you have Enhancer CD with your x5000 by default ?
Niolator wrote:@kas1e & Amigo1: You mean that you should get the Enhancer Software Pack with your X5000 motherboard? The only software I got was a burnt CD with the AmigaOS 4.1 installer. Could it be so that it is only bundled with complete systems and not if you just buy the motherboard?
Users browsing this forum: No registered users and 7 guests